The output will be visible in the “Nmap Output” tab. Make sure to adjust the IP address for the subnet you are on. If you find this output does not contain the MAC address, you can check the system ARP Table by running this command: arp -a Search for the Vega's MAC address in this output and you will be able to see the corresponding IP For Windows users: Run Zenmap and enter the command in the box as shown below. If you search through this output for the MAC address of the Vega, you will be able to see the corresponding IP for the device. Note the MAC address of the Vega Ethernet interface, which can be found on the sticker above the LAN port on the Vega.įor Linux users: run the following nmap command: nmap -sP Some versions of Nmap will output the IP and MAC address of every device on the subnet which responded to a ping. The device must be on the same subnet as the workstation you will be using to find the IP address. To begin, connect your Vega device to your network using the LAN 1 interface. For this to work the Vega must be set to DHCP (default) or a STATIC ip on the subnet directly attached to your Windows system.ĭownload -> Vega IP Scanner Method 2: Ping Sweep This will scan your entire subnet to find the Vega.

To find your Vega just download and run the Vega Scanner utility.

(Nmap windows download: ) (Nmap Linux: see distro repos or find sources here ) Workstation running Windows or Linux, with 'nmap' installed. You can then use the IP address to log into the Vega's web interface The methods below detail how to obtain the Vega's IP (based on the above DHCP description). By default (with default config) the Vega will obtain its IP address via DHCP with network cable plugged into LAN 1

How to get ip address of mac on linux